Sony DSR-50 - Manuel (Page 75)

Chapter 5 Duplication and Audio Dubbing
Chapter 5 Duplication and Audio Dubbing
75
(GB)
Notes
• If you have selected +48V ON, do not insert a
metal object into the AUDIO INPUT connectors.
It may cause electric shock.
• If you have selected +48V ON, use a microphone
that is compatible with 48 V. Using a microphone
that is incompatible may damage the microphone,
generate smoke or cause a fire.
3
Switch the audio input level control selectors to
select the audio input signal level (–60, –20 or +4).
Note
If you have set the audio input selectors to +48V
ON, set the audio input level control selectors to
–60.
4
Set the AUDIO SELECT switch to AUTO or
MANU.
5
Adjust the recording level by turning the audio
recording level control knobs.
You can adjust the recording level with the audio
recording level control knobs if you have selected
MANU in step
4 . While looking at the audio level
meters on the LCD monitor or the display window,
turn the audio recording level control knobs and
adjust the recording level. Adjust the audio
recording level so that the recording level does not
exceed 0 dB when the audio signal is at its
maximum. If the recording level exceeds 0 dB, the
OVER indicators light.
6
Set the tape in the unit (and the sound source, if
any) for dubbing.
7
While pressing the PAUSE button, press the PLAY
button to enter the playback pause mode.
8
While pressing the AUDIO DUB button, press the
PLAY button to enter the audio dubbing pause
mode.
9
Press the PAUSE button.
The AUDIO DUB indicator flashes and audio
dubbing starts.
To pause audio dubbing
Press the PAUSE button.
Pressing the PAUSE button again resumes audio
dubbing.
To stop audio dubbing
Press the STOP button.
To monitor the sound being dubbed
Set the MONITOR SELECT selector as follows:
CH1/2: You can listen to sound on channels 1/2 on
the tape or sound to be dubbed.
CH3/4: You can listen to sound on channels 3/4 on
the tape or sound to be dubbed.
MIX: You can listen to the sound on the tape and the
dubbed sound.
Note
You can monitor the sound on the tape while dubbing
the sound. However, there are some delays between
the sound being recorded and the sound being played.
When you play back the tape after audio dubbing, you
might hear the dubbed sound later than the sound
monitored during audio dubbing.