Sony DSR-50 - Manuel (Page 66)

Adjusting the Sync and Subcarrier Phases of the Video Signals
Chapter 4 Setting the Time Code and Adjusting the Video Signals
66
(GB) Chapter 4 Setting the Time Code and Adjusting the Video Signals
5
Play back a tape from this unit after setting EXT
SYNC on the VIDEO SET menu to ON.
6
Press the A channel button on the vectorscope.
The vectorscope displays the sync phase and
subcarrier phase (composite signals only) of the
signal from this unit.
7
Adjust the SYNC control using H PHASE on the
VIDEO SET menu for rough adjustment, then
adjust H PHASE F for fine adjustment, so that the
output from this unit on channel (A) is in correct
phase alignment with the black burst signal on
channel (B).
8
Adjust the SC control using SC PHASE on the
VIDEO SET menu for rough adjustment, then
adjust SC PHASE F for fine adjustment, so that the
output from this unit on channel (A) is in correct
phase alignment with the black burst signal on
channel (B).
Note
When component signals are used, the subcarrier
phase indicator does not appear.
Adjust the sync and subcarrier phase of the output
signal from this unit.
(for NTSC)
This indicator
moves as you
adjust the H
PHASE or H
PHASE F menu.
This indicator
moves as you
adjust the SC
PHASE or SC
PHASE F menu.
Adjust the sync and subcarrier phase of the output
signal from this unit.
(for PAL)
This indicator
moves as you
adjust the H
PHASE or H
PHASE F menu.
This indicator
moves as you
adjust the SC
PHASE or SC
PHASE F menu.