Sony DSR-50 - Manuel (Page 39)

Chapter 2 Preparations
39
(GB)
Chapter 2 Preparations
To video equipment without a DV jack (when using the DSR-50/50P as a player)
You can connect this unit to video equipment without a DV jack. Use this
unit as a player as follows.
The following shows an example configuration of dubbing a tape with its
time code in the externally-synchronized playback mode. In this
configuration, the recorder is a VCR equipped with component input
connectors.
Notes
• If you connect the input connectors of this VCR to the output connectors
of the monitor or recorder, a humming noise may be generated or the
image may be distorted.
• Text data (time code, warnings, menus, etc.) are superimposed only on
the signal sent to the VIDEO OUT1 output.
• To play back synchronized with the reference video (black burst) signal,
set the EXT SYNC on the VIDEO SET menu to ON.
Monitor
75
Ω
coaxial cable (not supplied)
DSR-50/50P (player) (right panel)
to the audio input
jack
to the video input
connector
Reference signal
generator
SG
to the
B.B.OUT
connector
to the
B.B.OUT
connector
75 Ω coaxial cable
(not supplied)
75
Ω
coaxial cable
(not supplied)
Phono jack cable (not
supplied)
to the REF.VIDEO
connector
recorder
to the time code
input connector
to the
audio
input
connectors to the
component input
connectors
75
Ω
coaxial cable
(not supplied)
Video cable (3BNC y 3BNC) (not supplied)
Conversion cable (XLR y phono) (not supplied)
: Signal flow Amplifier (as needed)