Sony UP-2100 - Manuel (Page 78)

78 Others
Error/Warning Messages (continued)
Message
INSERT RIBBON AND PAPER
REMOVE PRINTS
REMOVE PAPER: TRAY
Possible cause and remedies
The ink ribbon cartridge and paper are not loaded.
n Load the ink ribbon cartridge and paper. (pages 8 and 11)
The maximum number of printouts has accumulated on the paper cover.
n Remove the printouts from the paper cover. (page 79)
The paper jams around the paper tray as it is being fed into the ribbon area.
n Remove any jammed paper. (page 79)
Warning messages
In the case of a warning, only warning messages appear. The ALARM lamp does
not light.
Warning message
PLEASE WAIT
NOW PRINTING
HIT ANY KEY
INPUT MISMATCH
PLEASE WAIT
RESERVED MEMORY
PLEASE WAIT
PRINTING MEMORY
NO INPUT
NO IMAGE
PLEASE WAIT
HEAD IN COOLING
PLEASE WAIT
SET IN COOLING
Possible causes and remedies
The printer is printing, preventing any other operation.
n Wait until the printer finishes printing, then retry the operation.
This message appears when the remote control unit is used in CAPTURE STOP mode and when the
printer stops capturing images to memory pages once images have been captured to all memory pages.
n Press any button. Printer operation is enabled after this.
• The TV system of the signal input from the source equipment (VTR, video camera and so on) is not
compatible with the TV system of your printer.
n Check the signal of TV system and input the correct one.
• The signal other than the video signal (such as audio signal and similar) is input.
n Input the correct video signal.
Printing is queued for the selected memory page.
n Retry the operation once the printer finishes printing.
The image captured in the selected memory page is being printed.
n Retry the operation once the printer finishes printing.
The printer is not receiving an input signal from equipment corresponding to the input selected on the
INPUT SETUP menu.
n Check the input signal selected on the INPUT SETUP menu. (page 13)
n Check whether the video equipment is outputting a video signal in playback mode.
n Check that the connections between signal source equipment and the printer are secure. (page 65)
The image is not captured in memory.
n Capture the image in memory then start printing. (page 15)
The thermal head has overheated.
n Leave the printer until the head cools down and this message disappears. The printer starts printing
automatically.
The inside of the printer has overheated.
n Leave the printer until its inside cools down and this message disappears. The printer starts printing
automatically.