Location and function of parts – Sony 45P Manuel d'utilisation

Page 24

Advertising
background image

24

(GB)

Chapter 1

Overview

Location and Function of Parts

Chapter 1 Overview

3

Remote control section

Notes

• When controlling the unit using a device connected to

the RS-232C connector 1 or the RS-422A connector
2

, set the REMOTE/LOCAL switch on the front

panel to REMOTE. (Regardless of the setting of the
REMOTE/LOCAL switch, you can use a device
connected to the LANC jack 3 to control the unit.)

• Even when the DSR-45 plays back a PAL formatted

tape (or the DSR-45P plays back an NTSC formatted
tape), you can control the basic tape transport
functions using a device connected to the RS-232C
connector 1 or the RS-422A connector 2.
However, editing operations attempted in this case
are not guaranteed.

• For editing, if you intend to use this unit as a recorder

and to use the FXE-120/120P or the FXE-100/100P
upgraded by installing the FXE-KIT1 as an editing
controller, you also need to use the IF-FXE2 LANC
Interface Box.

1

RS-232C connector (9-pin)

Use when controlling the unit using an editing
controller or a computer that has an RS-232C
interface.

Note

For editing, if you intend to use this unit as a player
and the FXE-120/120P or FXE-100/100P as an editing
controller, set the baud rate of both devices to 19200
bps.

2

RS-422A connector (9-pin)

Use when controlling the unit using an editing
controller that has an RS-422A interface.

3

LANC jack

Use when controlling the tape transport operation of
the unit using a device that has a LANC

1)

jack.

Notes

• Regardless of the setting of the REMOTE/LOCAL

switch, you can use a device connected to the LANC
jack to control the unit.

• The LANC jack on the unit has only LANC-S

functions. The unit has no LANC-M functions. A
device that is set to LANC-S mode cannot be
connected to this unit. Either this, the unit or the other
device may not operate properly.

• If the device that you connect to this unit has a

SHUTTLE A/B switching function and a LANC-M
function, set the device to the SHUTTLE B mode.

• The LANC connection transmits signals such as

control signals, time code, time counter data, and
status data.

• Jacks labeled CONTROL L have the same function

as LANC jacks.

• When using this unit as a player, set the LANC mode

on the recorder to M. A device that does not have an
M / S switching function cannot be used to control
this unit.

4

Remote selector

Selects one from among RS-422A, RS-232C, or
LANC according to a device connected to the unit.

1

RS-232C connector

2

RS-422A connector

3

LANC jack

4

Remote selector

.........................................................................................................................................................................................................

1) LANC (Local Application Control bus system):

Bidirectional interface used to control a consumer VCR

Advertising