Precautions, Specifications, Troubleshooting – Sony SA-VE315 Manuel d'utilisation

Page 11

Advertising
background image

11

GB

Specifications

SA-VE315/VE312

SS-V315 (front and rear speakers)

Speaker system

Full range, magnetically
shielded

Speaker units

5

×

10 cm (2

×

4 in.),

cone type

Enclosure type

Bass reflex

Rated impedance

8 ohms

Power handling capacity
Maximum input power:

100 watts

Sensitivity level

87 dB (1 W, 1 m)

Frequency range

90 Hz - 20,000 Hz

Dimensions (w/h/d)

Approx. 68

Ч

150

Ч

125 mm (2

3

/

4

Ч

6

Ч

5 in.),

including front grille

Mass
European model:

Approx. 640 g (1 lb 7 oz)
each

Other models:

Approx. 740 g (1 lb 10 oz)
each

SS-CN315 (center speaker)

Speaker system

Full range

×

2,

magnetically shielded

Speaker units

5

×

10 cm (2

×

4 in.),

cone type

Enclosure type

Bass reflex

Rated impedance

8 ohms

Power handling capacity
Maximum input power:

120 watts

Sensitivity level

89 dB (1 W, 1 m)

Frequency range

90 Hz - 20,000 Hz

Dimensions (w/h/d)

Approx. 301

Ч

68

Ч

125 mm (11

7

/

8

Ч

2

3

/

4

Ч

5 in.), including front
grille

Mass
European model:

Approx. 1.4 kg (3 lb 1 oz)

Other models:

Approx. 1.5 kg (3 lb 5 oz)

Troubleshooting

Should you encounter a problem with your
speaker system, check the following list and
take the indicated measures. If the problem
persists, consult your nearest Sony dealer.

There is no sound from the speaker
system.

• Make sure all the connections have been

correctly made.

• Make sure the volume on the amplifier

has been turned up properly.

• Make sure the program source selector on

the amplifier is set to the proper source.

• Check if headphones are connected. If

they are, disconnect them.

There is distortion in the subwoofer sound
output.

• Check if any sound-enhancing functions

have been activated on the amplifier. If
they have, turn them off.

There is hum or noise in the speaker
output.

• Make sure all the connections have been

correctly made.

• Make sure none of the audio components

are positioned too close to the TV set.

The sound has suddenly stopped.

• Make sure all the connections have been

correctly made. Contact between bare
speaker wires at the speaker terminals
may cause a short-circuit.

continued

Advertising