Sony DCR-TRV355E Manuel d'utilisation

Page 155

Advertising
background image

155

Editing Montage

(1) Set the POWER switch to VCR on your

camcorder.

(2) On the connected VCR, locate just before the

insert start point [a], then press X to set the
VCR to the playback pause mode.

(3) On your camcorder, locate the insert end

point [c] by pressing m or M. Then press
X

to set your camcorder to the playback

pause mode.

(4) Press ZERO SET MEMORY on the Remote

Commander. The ZERO SET MEMORY
indicator flashes and the end point of the
insert is stored in memory. The tape counter
shows “0:00:00.”

(5) On your camcorder, locate the insert start

point [b] by pressing m. Press z REC and
the button on its right simultaneously, then
immediately press X to set your camcorder to
the recording pause mode.

(6) First press X on the VCR, and after a few

seconds press X on your camcorder to start
inserting the new scene.
Inserting automatically stops near the zero
point on the counter. Your camcorder
automatically stops. The end point [c] of the
insert stored in memory is cancelled.

Inserting a scene from a VCR
– Insert Editing

4

ZERO SET

MEMORY

5

0:00:00

ZERO SET

MEMORY

REC

PAUSE

(1) Réglez le commutateur POWER de votre

caméscope sur VCR.

(2) Sur le magnétoscope raccordé, arrêtez-vous

juste avant le point de début d’insertion [a],
puis appuyez sur X pour régler le
magnétoscope en mode de pause de lecture.

(3) Sur votre caméscope, repérez le point de fin

d’insertion [c] en appuyant sur m ou M.
Appuyez ensuite sur X pour régler votre
caméscope en mode de pause de lecture.

(4) Appuyez sur ZERO SET MEMORY sur la

télécommande. L’indicateur ZERO SET
MEMORY clignote et le point de fin
d’insertion est mémorisé dans l’appareil. Le
compteur de bande indique “0:00:00”.

(5) Sur votre caméscope, repérez le point de

début d’insertion [b] en appuyant sur m.
Appuyez simultanément sur z REC et sur la
touche à droite de REC, puis appuyez
immédiatement sur X pour régler votre
caméscope sur le mode de pause
d’enregistrement.

(6) Appuyez d’abord sur X sur le magnétoscope,

puis, après quelques secondes, appuyez sur X
sur votre caméscope pour lancer l’insertion de
la nouvelle scène.
L’insertion s’arrête automatiquement lorsque
le compteur de bande se rapproche de zéro.
Votre caméscope s’arrête automatiquement.
Le point de fin [c] de l’insertion enregistrée
dans la mémoire est supprimé.

Insertion d’une scène à partir d’un
magnétoscope – Montage à insertion

Advertising
Ce manuel est liée aux produits suivants: