Sony DCR-TRV355E Manuel d'utilisation

Page 127

Advertising
background image

127

Editing Montage

Dubbing a tape easily
– Easy Dubbing

Step 2: Setting the VCR to

operate with your
camcorder

Signals to control the VCR are sent from your
camcorder’s infrared rays emitter to the VCR’s
remote sensor.
When you connect using the A/V connecting
cable, follow the procedure below, steps (1) to
(4), to send the control signal correctly.

(1) Setting the modes to cancel

recording pause on the VCR

1

Set the POWER switch to PLAYER on
your camcorder.

2

Turn the power of the connected VCR on,
then set the input selector to LINE.
When you connect a video camera
recorder, set its power switch to VTR/
VCR.

3

Press EASY DUB to display the menu.

4

Turn the SEL/PUSH EXEC dial to select
SETUP, then press the dial.

5

Turn the SEL/PUSH EXEC dial to select
PAUSE MODE, then press the dial.

6

Turn the SEL/PUSH EXEC dial to select
the mode to cancel recording pause on the
VCR, then press the dial.

Copie facile d’une cassette
– Easy Dubbing

Etape 2 : Réglage du

magnétoscope pour
qu’il fonctionne avec
votre caméscope

Des signaux permettant de commander le
magnétoscope sont envoyés à partir de l’émetteur
de rayons infrarouges de votre caméscope vers le
capteur de télécommande du magnétoscope.
Lorsque vous connectez l’appareil en utilisant le
cordon de liaison audio et vidéo, suivez les étapes
(1) à (4) ci-dessous pour envoyer correctement le
signal de commande.

(1) Réglage des modes d’annulation

de pause d’enregistrement sur le
magnétoscope

1

Réglez le commutateur POWER sur
PLAYER sur votre caméscope.

2

Mettez le magnétoscope raccordé sous
tension, puis réglez le sélecteur d’entrée
sur LINE.
Lorsque vous connectez un
magnétoscope, réglez son commutateur
d’alimentation sur VTR/VCR.

3

Appuyez sur EASY DUB pour afficher le
menu.

4

Tournez la molette SEL/PUSH EXEC
pour sélectionner SETUP, puis appuyez
sur la molette.

5

Tournez la molette SEL/PUSH EXEC
pour sélectionner PAUSE MODE, puis
appuyez sur la molette.

6

Tournez la molette SEL/PUSH EXEC
pour sélectionner le mode d’annulation
de pause d’enregistrement sur le
magnétoscope, puis appuyez sur la
molette.

Advertising
Ce manuel est liée aux produits suivants: