Sony SPP-A947 - Manuel (Page 49)

Additional Information 49 US
Additional Information
Symptom
The handset does not ring
when calling from the base
phone.
Message is not recorded.
No sound from the speaker of
the base phone.
The caller’s message is
interrupted.
The clock is incorrect.
The phone does not accept your
remote ID code (security code).
The line is disconnected when
you call your phone from a
touch-tone phone.
The CHARGE lamp does not
light up when you place the
handset to charge.
The battery duration is short.
Answering machine
Operating from an
outside phone
Remedy
• The handset may be engaged in conversation.
• The battery may be weak. Charge the
battery for more
than 12 hours (page 9).
• Move the handset closer to the base phone.
• Place the base phone away from noise sources
(page 6).
• The remaining recording time is less than 30 seconds
or 59 messages were recorded. The answering
machine becomes “Memory full” status and does not
record messages. Erase messages (page 38).
• The message is less than two seconds. The answering
machine does not record messages less than two
seconds in length.
• Adjust the speaker volume (page 38).
• The caller’s message is too long.
• The caller’s voice is too low. The phone disconnects
the line when it detects seven seconds of silence.
• There was a power interruption. Reset the time
(page 30).
• Make sure you call from a touch-tone phone.
• Make sure the remote ID code (security code) is
correct.
• Make sure you entered the remote ID code (security
code) within two seconds after you‘ve entered (#).
• You entered wrong remote ID codes (security codes)
three times.
• Wipe the charge terminals of the base phone and the
handset with a soft cloth for better contact of the
charge terminals.
• Make sure the handset is placed on the base phone
properly.
• The battery pack was charged less than 12 hours (due
to power failure, etc.).
• The usage life of the battery has expired and needs
replacement.
Intercom
Power source/battery
continued