Hooking up the system, Getting started, Hookups – Sony XE370 Manuel d'utilisation

Page 7

Advertising
background image

Getting Started

7

GB

Getting Started

Inserting Batteries Into
the Remote Control (CDP-
XE570/XE370 only)

You can control the player using the supplied
remote.

Insert two R6 (size AA) batteries by matching
the + and – on the batteries to the diagram
inside the battery compartment.

Insert the negative (–) end first, then push in
and down until the positive (+) end clicks into
position.

When using the remote, point it at the remote
sensor

on the player.

Tip

When the remote no longer operates the system,
replace both batteries with new ones.

Note

• Do not leave the remote near an extremely hot or

humid place.

• Do not drop any foreign object into the remote

casing, particularly when replacing the batteries.

• Do not expose the remote sensor to direct sunlight

or lighting apparatuses. Doing so may cause a
malfunction.

• If you don’t use the remote for an extended period

of time, remove the batteries to avoid possible
damage from battery leakage and corrosion.

Hooking Up the System

Hookups

This section describes how to hook up the CD
player to an amplifier. Be sure to turn off the
power of each component before making the
connections.

Note

Install this system so that the power cord can be
unplugged from the wall socket immediately in the
event of trouble.

Tip (CDP-XE570/XE370 only)

You can adjust the analog output level to the
amplifier using the remote comes with this player.
Press ANALOG OUT LEVEL +/– on the remote.
You can reduce the analog output level up to –20 dB.
When you reduce the analog output level, “FADE”
(or

FADE

for the CDP-XE370) appears in the display.

When you turn off the player, the output level
automatically returns to the maximum level.

CD player

Audio input
(White) (L)

: Signal flow

Amplifier

To mains

To mains

Audio input
(Red) (R)

ANALOG
OUT
(Red) (R)

ANALOG OUT
(White) (L)

continued

Advertising
Ce manuel est liée aux produits suivants: