JVC AV 27320 - Manuel (Page 11)

11
Getting Started
These quick setup pages will provide you, in three easy steps, with the basic information you
need to begin using your new television right away. This information includes basic instructions
on operating your remote control, making a simple cable/antenna and optional VCR connection
and, finally, information on programming your television's Auto Tuner.
If you have questions, or for more detailed information on any of these steps, please consult
other sections of this manual.
Step One - The Remote Control
The remote control is the key to operating your television's many great features. Before you can
operate your remote control, you first need to install the batteries (included).
For RM-C255, RM-C253 and RM-C252, lift and pull the latch on the back of the remote to
open. For RM-C205, raise the latch on the remote’s back cover to remove. Insert two batteries
(included) carefully noting the “+” and “–” markings, placing the “–” end in the unit first. Snap the
cover back into place.
Basic Operation
Turn the television on and off by pressing the P OWER button at the top right corner of
the remote.
The four key feature buttons at the center of the remote can be
used for basic operation of the television. The top and bottom
buttons will scan forward an back through the available chan-
nels. The right and left buttons will turn the volume up or down.
These buttons are also marked with four arrows and are also
used with JVC's onscreen menu system. You will need to use
these buttons later in the Quick Setup.
The next step is to connect your television to an antenna or
cable.
Note: Illustration of remote control RM-C252
POWER
Proceed to Step Two
Quick Setup 1
RM-C205 ONLY RM-255, RM-C253 and RM-252
FE English 5/13/02 8:52 AM Page 11