Insignia NS-LCD26F - Manuel (Page 8)

6
Insignia NS-CL26C LCD TV
www.insignia-products.com
2 Connect RCA video and audio cables from
the DVD player to the VIDEO and AUDIO IN
jacks on the back of your TV.
• Yellow - Video
• White - Audio left
• Red - Audio right
- OR -
Connect an S-Video cable and audio cables
from the DVD player to the S-VIDEO and
AUDIO IN (L and R) jacks on the back of your
TV.
• White - Audio left
• Red - Audio right
- OR -
Connect RCA cables to the DVD’s
COMPONENT VIDEO Out jacks and the
AUDIO OUT jacks (L and R), then to the
COMPONENT IN jacks (Y, Cb/Pb, and Cr/Pr)
and the AUDIO IN (L and R) jacks on the
back of the TV.
3 Turn on the TV and the VCR.
4 Press the INPUT button to set the TV’s signal
input to S-VIDEO or YPbPr (as appropriate).
To connect your TV to a DVD player with an
HDMI cable:
1 Turn off the TV and the DVD player.
2 Connect an HDMI cable to the HDMI output
jack on the DVD player, then connect it to the
HDMI jack on your TV.
3 Press the INPUT button to set the TV’s signal
input to HDMI.
Connecting to a cable box
To connect your TV to a cable box with an RF
cable:
1 Turn off the TV and the cable box.
2 Connect a 75 ohm RF cable from the cable
box to the ANT. jack on the back of your TV.
3 Set the cable box output switch to channel 3
or 4, then tune your TV to the same channel.
4 Turn on the TV and the cable box.
5 Change channels at the cable box or with the
cable box remote.
To connect your TV to a cable box with a AV
cables:
1 Turn off the TV and the cable box.
2 Connect RCA video and audio cables from
the cable box to the VIDEO and AUDIO IN
jacks on the back of your TV.
• Yellow - Video
• White - Audio left
• Red - Audio right
3 Turn on the TV and the cable box.
4 Press the INPUT button to set the TV’s signal
input to AV1.
5 Change channels at the cable box or with the
cable box remote.
Connecting to a computer
To connect a computer video source to the
VGA jacks:
1 Connect a VGA cable from the computer to
the VGA jack on the TV.
2 Connect a male-to-male audio cable from the
computer to the VGA-AUDIO port on the TV.
3 Turn on the TV, then turn on the PC.
4 Press the INPUT button to set the TV’s signal
input to VGA.
-