Insignia NS-LCD26F - Manuel (Page 7)

5
Insignia NS-CL26C LCD TV
www.insignia-products.com
Setting up your TV
Installing the remote control batteries
To install the batteries:
1 Open the battery compartment (1) on the
back of the remote control.
2 Insert the two AA batteries (2)(provided) into
the battery compartment. Make sure that the
(+) and (-) symbols on the batteries match
the diagram inside the compartment.
3 Close the battery compartment (3).
Using the remote control
To use the remote control:
•
Point it directly at the TV, within a 30° angle of
the IR sensor on the front of the TV, and
within 20 feet.
Connecting to video sources
Connecting to an antenna or cable/satellite
receiver
To connect an external antenna or cable/
satellite receiver:
1 Connect the antenna cable from an antenna
or cable/satellite receiver to the antenna input
jack on the TV.
2 Press the INPUT button to set the TV’s signal
input to TV.
Connecting to a VCR
To connect your TV to a VCR:
1 Turn off the TV and the VCR (or other
source).
2 Connect an RF cable to the VCR, then to the
ANT. jack on the back of the TV.
3 Connect RCA audio cables to the VCR’s
audio output jacks, then to the AV IN L and R
jacks on the back of the TV.
4 Turn on the TV and the VCR.
5 Press the INPUT button to set the TV’s signal
input to TV.
Connecting to a DVD or other video source
To connect your TV to a DVD or other video
source:
1 Turn off the TV and the DVD (or other
source).
30 NEXT button. Press to go to the next chapter or
track. Press again to skip forward by chapter or track.
31 PREV button. Press to go to the previous chapter or
track. Press again to skip back by chapter or track.
32
STOP button. Press to stop DVD and CD playback.
33
PAUSE/STEP button. Press to pause DVD playback.
Press again to step through a DVD one frame at a time.
34 SLOW button. Press to decrease the DVD playback speed.
35 SEARCH button. Press to go to DVD search mode.
36 ZOOM button. Press to zoom the display image in on the
picture.
37 A-B button. Press to repeat a selected portion of a DVD.
38 REPEAT button. Press to go to DVD repeat mode.
Item Description
1 2 3
Note
Objects between the remote control and the
sensor may weaken the remote control’s IR signal.
Range can be diminished by direct sunlight
shining on the TV’s IR sensor.
Cautions
Do not expose the remote control to liquids, direct
sunlight, or shock.
The remote control may not work correctly if the
TV’s IR sensor is under direct sunlight or strong
lighting. In these cases, change the angle of the
lighting or the TV screen, or operate the remote
control closer to the IR sensor.
Notes
• To improve picture quality in a poor signal area,
you can purchase and install a signal amplifier.
• To split the signal from an antenna, you will
need a 2-way signal splitter.