Fisher PLC-XU86 - Manuel (Page 30)

30
Computer Input
Choose Computer 1(Digital) by pressing the INPUT button
on the top control or press the COMPUTER button on the
remote control.
Before using these buttons, correct input source should be
selected through Menu operation as described below.
Press the MENU button to display the On-Screen
Menu. Press the Point
7 8 buttons to move the red
framed pointer to the Input Menu icon.
1
Input Menu
Press the Point ed buttons to move the red arrow
pointer to Computer 1(Digital), and then press the
SELECT button.
2
After the Source Select Menu appeared for Computer
1(Digital), move the pointer to RGB (PC digital) or RGB
(AV HDCP) and then press the SELECT button. 3
COMPUTER button
INPUT button
Input Source Selection (RGB(PC digital), RGB(AV HDCP))
Direct Operation
Menu Operation
Move the pointer
(red arrow) to
Computer 1 (Digital)
and press the
SELECT button.
Input Menu icon
Remote Control
Top Control INPUT button
COMPUTER button
ON
- OFF
POWER
AUT INPUT
WARNING LA
MENU
SELECT
✔
Note:
•Computer 2 is not displayed when the COMPUTER IN 2 /
COMPONENT IN / MONITOR OUT terminal is set as Monitor out.
(p50)
•Computer 2 (COMPUTER IN 2 / COMPONENT IN / MONITOR
OUT) can accept only RGB signal.
•HDCP (High-bandwidth Digital Content Protection) is a system for
protecting digital entertainment content delivered by DVI (Digital
Visual Interface) from being copied. The specification of HDCP is
decided and controlled by Digital Content Protection, LLC. Should
the specification be changed, this projector may not display the
digital content protected by HDCP.
•Wired, Wireless, Memory Viewer are for the Network function.
See owner's manual (Additional Vol.) and owner's manual of
Memory viewer (optionally available).
Move the pointer to
the source that you
want to select and
press the SELECT
button.
Computer
1
Computer 1
(Analog/Digital)
Video
Computer 2
✳
Wired
Computer 2
✳ See Note at the bottom of this page.
✳
Computer 1
(Analog/Digital)