Fisher PLC-XU86 - Manuel (Page 17)

17
NOTE ON THE POWER CORD
AC power cord must meet requirement of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
If supplied AC power cord does not match your AC outlet, contact your sales dealer.
To power cord
connector on your
projector.
Projector side AC outlet side
Ground
To the AC outlet.
(120 V AC)
For Continental Europe For the U.S.A. and Canada
This projector uses nominal input voltages of 100-120 V or
200-240 V AC. This projector automatically selects the
correct input voltage. It is designed to work with single-
phase power systems having a grounded neutral conductor.
To reduce the risk of electrical shock, do not plug into any
other type of power system.
Consult your authorized dealer or service station if you are
not sure of the type of power being supplied.
Connect the projector with all peripheral equipment before
turning the projector on. (See page 18-20 for connection.)
CAUTION
For safety, unplug the AC power cord when the projector
is not in use. When this projector is connected to an
outlet with the AC power cord, it is in Stand-by mode and
consumes a little electric power.
Connecting the AC Power Cord
Connect the AC power cord (supplied) to the
projector.
The AC outlet must be near this equipment and
must be easily accessible.
For the U.K.
To the AC outlet.
(200 - 240 V AC)
To the AC outlet.
(200 - 240 V AC)
Installation
Installation