Fisher PLC-XU86 - Manuel (Page 13)

13
Part Names and Functions
Spotlight
Pointer Function
Pointer
✔
Note:
You can choose the size of Spotlight (Large, Middle, and Small) and
the pattern of Pointer (Arrow, Finger, and Dot) in the Setting Menu.
See “Pointer” on page 51.
This remote control emits a laser beam from the laser light window. With the LASER button pressed, laser light
goes on. The signal emission indicator lights red and laser is emitted with red light. With the LASER button
pressed for more than 1 minute or released, the light goes off.
The laser emitted is a class II laser. Do not look into the laser light window or shine the laser beam on yourself
or other people. Below are the caution labels for laser beam.
CAUTION : Use of controls, adjustments or performance of procedures other than those specified herein
may result in hazardous radiation exposure. Do not look into the laser light window while laser
is emitted, otherwise eye damage may result.
Laser Light Window
These caution labels are put on the remote control.
Signal Emission Indicator
Laser Pointer Function
You can move Spotlight or Pointer of the projector with the remote control to emphasize a part of the projected
image.
With pressing the MENU button, hold down the NO
SHOW button for more than 10 seconds so that the
Pointer function will be available. (The Laser pointer
has switched to the Pointer.) 1
While pressing the MENU
button, hold down the NO
SHOW button for more than 10
seconds.
Press the LASER button on the remote control toward
the projector. Spotlight or Pointer is displayed on the
screen with the LASER button lighting green. Then
move the Spotlight or Pointer with the
PRESENTATION POINTER button. If the LASER
button does not light green and still emits laser beam,
try the procedure above until the LASER button lights
green. 2
To clear the Spotlight or Pointer out the screen, press
the LASER button toward the projector and see if the
LASER button lighting turns off.
To switch back to the Laser pointer again, hold down
the NO SHOW button with pressing the MENU button
for more than 10 seconds or slide the RESET/ON/ALL-
OFF switch to "RESET". (p12) When you reset the
Pointer function, the remote control code will be reset,
as well. 3
After the Laser pointer has
switched to the Pointer, use
the LASER button as the
Pointer function ON-OFF
switch. Press the LASER
button toward the projector and
see if it lights green.
LASER button
PRESENTATION POINTER button
PRESENTATION POINTER button
MENU button
NO SHOW button
Pa
rt
Names and Functions