Freecom Technologies RCS-M2000U - Manual (Page 16)

TROUBLESHOOTING
Before contacting a dealer or qualified service technician, please read and check
the following:
SOLUTION
1. Make sure city power supply is normal.
2. Check plug is correctly installed into outlet.
3. Check fuses and household breaker
switches.
4. Remove electrical plug from outlet. Check electri-
cal cord and plug for damage.
5. Check to be sure water tank is installed properly
into unit.
6. Check that plug is secure and in place on con-
densate tube.
7. Check louvers and grills for obstacles or debris.
8. Check room temperature. Room temperature
should not be below 60ÞF (15ÞC) or above
95ÞF (35ÞC).
9. Compressor delay feature may be active. Unplug
unit and wait for 3-5 minutes. Plug unit into out-
let and press "POWER ON/OFF" switch.
1. Check and clean air filter.
2. Check louvers and grills for obstacles or debris.
3. Check MODE and/or THERMO CONTROL
selection and adjust for higher air output. (See
"OPERATION.")
4. Allow unit to stand upright for a minimum of two
hours before attempting to operate.
1. Check that unit is on a flat, level, solid surface.
2. Check filter and tank are installed properly.
3. Turn unit off. Check louvers and grills for
obstructions.
4. Allow unit to stand upright for a minimum of two
hours before attempting to operate.
1. Check that unit is on a flat, level, solid surface.
2. Check that plug is secure and in place on con-
densate tube.
PROBLEM
Unit does not turn on.
Unit running low air flow or
cooling.
Unit noisy when operating.
Water leaking from unit.